Guidance for Industry and Food and Drug Administration Staff; Class II Special Controls Guidance Document: Wound Dressing With Poly (Diallyl Dimethyl Ammonium Chloride) Additive; Availability
The Food and Drug Administration (FDA) is announcing the availability of the guidance entitled “Class II Special Controls Guidance Document: Wound Dressing With Poly (Diallyl Dimethyl Ammonium Chloride) (pDADMAC) Additive.” This guidance document describes a means by which wound dressing with Poly (diallyl dimethyl ammonium chloride) (pDADMAC) additive may comply with the requirement of special controls for class II devices. Elsewhere in this issue of the Federal Register, FDA is publishing a final rule to classify wound dressing with pDADMAC additive into class II (special controls). This guidance document is being immediately implemented as the special control for wound dressing with pDADMAC additive, but it remains subject to comment in accordance with the agency's good guidance practices (GGPs).
Table of Contents
- I. Background
- II. Significance of Guidance
- III. Electronic Access
- IV. Paperwork Reduction Act of 1995
- V. Comments
Submit written or electronic comments on the guidance at any time. General comments on agency guidance documents are welcome at any time.
Submit written requests for single copies of the guidance document entitled “Class II Special Controls Guidance Document: Wound Dressing With Poly (Diallyl Dimethyl Ammonium Chloride) (pDADMAC) Additive” to the Division of Small Manufacturers, International, and Consumer Assistance, Center for Devices and Radiological Health (CDRH), Food and Drug Administration, 10903 New Hampshire Ave., Bldg. 66, rm. 4613, Silver Spring, MD 20850. Send one self-addressed adhesive label to assist that office in processing your request, or fax your request to 301-847-8502. See the SUPPLEMENTARY INFORMATION section for information on electronic access to the guidance.
Submit written comments concerning this guidance to the Division of Dockets Management (HFA-305), Food and Drug Administration, 5630 Fishers Lane, rm. 1061, Rockville, MD 20852. Submit electronic comments to http://www.regulations.gov. Identify comments with the docket number found in brackets in the heading of this document.
For further information contact: ↑
Sam Arepalli, Center for Devices and Radiological Health (HFZ-410), Food and Drug Administration, 10903 New Hampshire Ave., Bldg. 66, rm. 3612, Silver Spring, MD 20993, 301-796-6434.
Supplementary information: ↑
I. Background ↑
Elsewhere in this issue of the Federal Register, FDA is publishing a final rule classifying into class II (special controls) under section 513(f)(2) of the Federal Food, Drug, and Cosmetic Act (the act) (21 U.S.C. 360c(f)(2)). This guidance document will serve as the special control for wound dressing with pDADMAC additive. Section 513(f)(2) of the act provides that any person who submits a premarket notification under section 510(k) of the act (21 U.S.C. 360(k)) for a device that has not previously been classified may, within 30 days after receiving an order classifying the device in class III under section 513(f)(1) of the act, request FDA to classify the device under the criteria set forth in section 513(a)(1) of the act. FDA shall, within 60 days of receiving such a request, classify the device by written order. This classification shall be the initial classification of the device. Within 30 days after the issuance of an order classifying the device, FDA must publish a notice in the Federal Register announcing such classification. Because of the timeframes established by section 513(f)(2) of the act, FDA has determined, under § 10.115(g)(2) (21 CFR 10.115(g)(2)), that it is not feasible to allow for public participation before issuing this guidance as a final guidance document. Thus, FDA is issuing this guidance document as a level 1 guidance document that is immediately in effect. FDA will consider any comments that are received in response to this notice to determine whether to amend the guidance document.
II. Significance of Guidance ↑
This guidance is being issued consistent with FDA's GGPs regulation (§ 10.115). The guidance represents the agency's current thinking on wound dressings with pDADMAC additive. It does not create or confer any rights for or on any person and does not operate to bind FDA or the public. An alternative approach may be used if such approach satisfies the requirements of the applicable statute and regulations.
III. Electronic Access ↑
Persons interested in obtaining a copy of the guidance may do so by using the Internet. To receive “Class II Special Controls Guidance Document: Wound Dressing With Poly (Diallyl Dimethyl Ammonium Chloride) (pDADMAC) Additive,” you may either send an e-mail request to firstname.lastname@example.org to receive an electronic copy of the document or send a fax request to 240-276-3151 to receive a hard copy. Please use the document number 1684 to identify the guidance you are requesting.
CDRH maintains an entry on the Internet for easy access to information including text, graphics, and files that may be downloaded to a personal computer with Internet access. Updated on a regular basis, the CDRH home page includes device safety alerts, Federal Register reprints, information on premarket submissions (including lists of approved applications and manufacturers' addresses), small manufacturer's assistance, information on video conferencing and electronic submissions, Mammography Matters, and other device-oriented information. The CDRH Web site may be accessed at http://www.fda.gov/cdrh. A search capability for all CDRH guidance documents is available at http://www.fda.gov/cdrh/guidance.html. Guidance documents are also available at http://www.regulations.gov.
IV. Paperwork Reduction Act of 1995 ↑
This guidance refers to previously approved collections of information found in FDA regulations. These collections of information are subject to review by the Office of Management and Budget (OMB) under the Paperwork Reduction Act of 1995 (the PRA) (44 U.S.C. 3501-3520). The collections of information in 21 CFR part 807, subpart E have been approved under OMB control number 0910-0120; the collections of information in 21 CFR part 820 have been approved under OMB control number 0910-0073; and the collections of information in 21 CFRpart 801 have been approved under OMB control number 0910-0485.
V. Comments ↑
Interested persons may submit to the Division of Dockets Management (see ADDRESSES) written or electronic comments regarding this document. Submit a single copy of electronic comments or two paper copies of any mailed comments, except that individuals may submit one paper copy. Comments are to be identified with the docket number found in brackets in the heading of this document. Received comments may be seen in the Division of Dockets Management between 9 a.m. and 4 p.m., Monday through Friday.Dated: October 2, 2009. Jeffrey Shuren, Acting Director, Center for Devices and Radiological Health.